I'm planning on having a viv built and what i was hoping was that the front would be full glass so that i get to see the reps as much as possible.

My intention was to have a solid panel of glass running the length of the viv at the top and the bottom, fixed in place with runners on all sides. They wouldn't be removeable.

In between them i would have the sliding glass doors, framed again on all sides with glass runners. The top and bottom runners would be back to back with the solid panel runners and runners at the sides would be glued in place.

Would that be stable?

Thanks

ye would be fine, had a viv like that meself a while back, gave it to me girlfriend otherwise ya could of had it. Will c if i can find some pics of similar vivs for ya 2 see.

Yeh, if you could find them that would be great! I'm trying to convince my fella it will be ok

Do you mean ones like this?? this is similar to one i had, its just a bit taller.

Heres a better one, think this is what ya trying to achieve, the front is held in by runners as you can see, should be ok just make sure everythin is well sealed with some rreally strong glue, check out the DIY shops for the best sort, explain what its for and they'll sort somethin for ya. Good luck anyhow

Wooden Terrarium, 120x50x50 cm

Had to post link, wouldnt seem to let me post the pic

Thanks for the pics

The glass one kinda shows what i'm after more on the front, but i'm after the rest of it being wooden.

If it can work with glass being held together with silicon glue then it should be fine with wood i reckon. I was just nervous off the whole front falling out lol