Reptile Forums banner
1 - 11 of 11 Posts

·
Registered
Joined
·
7,908 Posts
Discussion Starter · #1 ·
hi,

i was wondering what was the best thermostat to use for in a beardie egg incubator, in my viv i have a cobrastat, this was advised by the petshop, would one of these be ok in the incubator, it goes off when it gets too hot and comes on when it gets a little bit cooler, will this be ok?? and if not then what sort of stat should i use??

thanks,

luke
 

·
Registered
Joined
·
13,922 Posts
Whats heating your incubator?

Personally, my fave would be a pulse stat - Habistat Pulse stat to be precise. :)
 

·
Registered
Joined
·
7,908 Posts
Discussion Starter · #4 ·
its going to be a heat mat i think, or would the water with a fish tank heater be better? as the water one would be easier for me and if i use the water one i wont need a stat
 

·
Registered
Joined
·
7,908 Posts
Discussion Starter · #6 ·
will the water with a fish tank heater work with beardie eggs?
 

·
Registered
Joined
·
7,287 Posts
its going to be a heat mat i think, or would the water with a fish tank heater be better? as the water one would be easier for me and if i use the water one i wont need a stat
The fish tank heater one is easier but the heat mat way would be safer. There's pros and cons to each just weigh them up for yourself.
 

·
Registered
Joined
·
31,364 Posts
i use the heat mat with a mat stat :) and i have hatched out 5 cresties this year :)
 

·
Registered
Joined
·
7,908 Posts
Discussion Starter · #9 ·
is a matstat what im using in my viv? or another kind? i think the heatmat incubator is better:)
 

·
Registered
Joined
·
7,908 Posts
Discussion Starter · #11 ·
ok:) thanks:) ill try it:)
 
1 - 11 of 11 Posts
Top